Laminate Countertops Pulling Away From Wall

Step 7 pry counter loose.

Laminate countertops pulling away from wall.

Easy way to perfectly caulk the gap between countertop and wall. When you install wood look kitchen laminate countertops you get the warmth of wood with the convenience ease and hygienic nature of laminate surfacing like the countertops featured in this kitchen designed by palazzo kitchens and design. It is actually the 2x6 stud that is causing the problem. Place a paint scraper between the backsplash and the wall and drive it downward with a few taps of a hammer image 1.

Sometimes the added pressure and weight of cabinets above the countertop can cause movement in the countertops and cause them to jut slightly away from the wall again creating a gap. Actually the counters are not pulling away from the wall the wall is bowing away from the counters. Pull up slightly on the countertop when you re finished to confirm that all the screws have been removed. Remove the backsplash there is more silicone adhesive on the back of the backsplash.

You may not be able to raise the front much but sometimes you can raise it 1 2 inch or more. The top is held in place fastend to by the cabinets below it. Even more interesting is the fact that we never had this problem when we build houses with 2x4 studs. Loook in the cabinets to what has let loose.

The walls shifting can sometimes cause the countertop and wall to split away thus creating a small gap. As stone look laminate countertops have skyrocketed in popularity wood styles lagged behind. Palazzo kitchens and design. Step 2 apply a glue dissolving solvent to the area between the backsplash and the wall.

The cabinets must have moved. Insert a flat bar under the toe kick of the cabinet and pry up the front of the unit to push the countertop closer to the wall. Do this along the length of the backsplash until the backsplash is mostly detached from the wall. Peel back loose portions of the laminate backsplash or pry some of the backsplash away from the wall using the method explained in section 1.

Allow the solvent to sit according to the manufacturer instructions. Work the end into the seam between the counter and the lower cabinet hammering the end to wedge it in further if you need to. If your countertop is secured with glue instead you will have to work it loose from the adhesive using a pry bar.